Replacement for Cim-Tek 30037 Element for Housings and Vessels
$42.85
Direct replacement for Cim-Tek 30037 hydraulic filter in form, fit, and function. Made in America with ISO 9001:2015 Certified manufacturing for assured quality. Optimized filter media is used for fine filtration, long life, and high dirt-holding capacity.
- 6.0″ OD x 2.62″ ID Top x 18.0″ Length overall
- 25 Micron with Water Absorbent per ISO 16889
- 100 PSID Collapse Pressure
- Replaces Cim-Tek 30037 hydraulic filter in form, fit, and function. Scroll down for additional specs
There is a minimum quantity of six per order.
SONA Filtration reviews:
Part numbers and names are used for cross reference only. Part numbers indicated as replacements are not manufactured or affiliated with the OEM or Brand listed.
| O.D. | 6.0" |
|---|---|
| I.D. Top | 2.62" |
| I.D. Bottom | 2.62" |
| Length Overall | 18.0" |
| Construction Type | Cellulose with Water Absorbing function, Double Open End |
| Efficiency | 25 Micron with Water Absorbent |
| Gasket Material | Buna |
| Wire Support | NA |
| Max Operating Pressure | 100 PSID Collapse Pressure |
| Max Temp | 248 Degress F |
| Weight Each | 7 |
| Carton Qty | 6 per carton |
| Condition | New |
Our Cim-Tek 30037 Replacement Filter
Our Cim-Tek 30037 replacement hydraulic filter is a guaranteed direct replacement in form, fit, and function. This means the filter will fit and you should expect performance to be equal to or greater than the OEM filter. Made in America.
Filtration Media for the Cim-Tek 30037 direct interchange
Our filter media is backed by ISO 16889 multi-pass testing and other ISO/SAE test protocols and the filter is produced in an ISO Certified manufacturing facility. An ISO Certified manufacturing facility is all about quality control, consistency, responsibility, and being true to the design. Optimized media is used for fine filtration, just like the Cim-Tek 30037 hydraulic filter to be replaced. Our filters use the optimal amount of media and pleats to ensure high dirt-holding capacity. The correct number and design of pleats in the element will give you the lowest initial pressure drop. Therefore the filter will take longer to reach its change-out pressure drop which is usually 25 PSID.
Micron Rating for the Cim-Tek 30037 cross
This Cim-Tek 30037 hydraulic filter replacement element is beta-rated. The filter performance is outstanding.
- 25 Micron with Water Absorbent
Filter Collapse Pressure for the Cim-Tek 30037 cross reference
A filter collapse pressure of 100 PSID Collapse Pressure means that if the filter is completely clogged and the build up of pressure reaches or surpasses 100 PSID Collapse Pressure the filter may collapse and allow contamination downstream. Please use a satisfactory safety factor for the filter.
Compatible Fluids
This filter is compatible with the following fluids but pressure drop will vary depending on viscosity and temperature:
- Hydraulic Fluid and Machining Fluids
- Diesel and other fuels
- Lubricating Oils and Synthetic Lubricants
- Turbine and Compressor Lube Oils … And many more fluids
Visit the links below for more helpful information.
Our hydraulic filter is indicated as a replacement for Cim-Tek 30037 and is not manufactured by or affiliated with the OEM or Brand listed. Part numbers and names are used for cross reference only. The element may vary from the image displayed on the left.
Reviews
There are no reviews yet. Be the first one to write one.