SONA Filtration Reviews:
Replacement for FPC FPE70100M Spin-On Filter
Direct replacement for FPC FPE70100M spin-on filter in form, fit, and function. Made in America with ISO 9001:2015 Certified manufacturing for assured quality. Optimized filter media inside the spin-on filter is used for fine filtration, long life, and high dirt-holding capacity.
- 5.06″ OD x 10.94″ Length x 1-1/2″ UNF Thread
- 125 Micron
- 261 Burst, 145 Collapse
- Replaces FPC FPE70100M spin-on filter in form, fit, and function. Scroll down for additional specs
There is a minimum quantity of two per order.
Part numbers and names are used for cross reference only. Part numbers indicated as replacements are not manufactured or affiliated with the OEM or Brand listed.
Stainless Steel Wire Mesh
|Max Operating Pressure||
145 Collapse, 261 Burst
248 Degress F
SONA FPC FPE70100M Replacement Spin-On Filter
Our FPC FPE70100M replacement spin-on filter is a guaranteed direct replacement in form, fit, and function. This means the filter will fit and you should expect performance to be equal to or greater than the OEM filter. Made in America.
Filtration Media for the FPC FPE70100M direct interchange
Our filter media is backed by ISO 16889 multi-pass testing and other ISO/SAE test protocols and the filter is produced in an ISO Certified manufacturing facility. An ISO Certified manufacturing facility is all about quality control, consistency, responsibility, and being true to the design. Optimized media is used for fine filtration, just like the FPC FPE70100M spin-on hydraulic filter to be replaced. Our spin-on filters use the optimal amount of media and pleats to ensure high dirt-holding capacity. The correct number and design of pleats in the element will give you the lowest initial pressure drop. Therefore the filter will take longer to reach its change-out pressure drop which is usually 25 PSID.
Micron Rating for the FPC FPE70100M cross
This FPC FPE70100M spin-on filter replacement element is beta-rated. The filter performance is outstanding. The Beta X = 1000 number means that for every 1000 particles of x size in the fluid only one particle will pass through the filter on average.
- 125 Micron
Filter Burst Pressure for the FPC FPE70100M cross reference
A filter burst pressure of 261 Burst, 145 Collapse means that if the filter is completely clogged and the build up of pressure reaches or surpasses 261 Burst, 145 Collapse the filter may burst at the gasket or allow contamination downstream. Please use a satisfactory safety factor for the filter.
This filter is compatible with the following fluids but pressure drop will vary depending on viscosity and temperature:
- Hydraulic Fluid and Machining Fluids
- Diesel and other fuels
- Lubricating Oils and Synthetic Lubricants
- Turbine and Compressor Lube Oils … And many more fluids
Visit the links below for more helpful information.
Our hydraulic filter is indicated as a replacement for FPC FPE70100M and is not manufactured by or affiliated with the OEM or Brand listed. Part numbers and names are used for cross reference only. The element may vary from the image displayed on the left.