Sale! 6% off!

Replacement for Case R25844 Spin-On Filter

$26.47 $25.00

Guaranteed direct replacement for Case R25844 spin-on filter in form, fit, and function. Made in America with ISO 9001:2015 Certified manufacturing for assured quality. Optimized filter media inside the spin-on filter is used for fine filtration, long life, and high dirt-holding capacity.

  • 5 OD x 7 Length x 1-1/2-16 UN Thread
  • 10 micron per ISO 16889
  • Buna gasket and a maximum temperature of 248 Degrees
  • 288 Burst
  • Replaces Case R25844 spin-on filter in form, fit, and function. Scroll down for additional specs

Part numbers and names are used for cross reference only. Part numbers indicated as replacements are not manufactured or affiliated with the OEM or Brand listed.

Buy 12 or more filters, GET FREE SHIPPING to the 48 contiguous U.S. states

SKU: S120338-0058057




I.D. Top

1-1/2-16 UN

I.D. Bottom


Length Overall


Construction Type



10 micron

Gasket Material


Gasket Type


End Cap Material

Tin Plate Steel


Tin-Plate Louvered

Wire Mesh Support?


Change-Out PSID


Max Operating Pressure

288 Burst

Max Temp

248 Degrees

Weight Each



Our Case R25844 replacement hydraulic spin-on filter is a guaranteed direct replacement in form, fit, and function.

Our filter media is backed by ISO 16889 multi-pass testing and other ISO/SAE test protocols, (common test methods) and the spin-on filter is produced in an ISO Certified manufacturing facility. Why does that matter? Isn’t it good enough to use the same media as OEM filters. In a word, NO. An ISO Certified manufacturing facility is all about quality control, consistency, responsibility, and being true to the design intention. If you’re not ISO 9001 Certified, your approach to quality and consistency is all talk.

This Case R25844 replacement spin-on filter is rated ‘nominal’. Not sure what that really means? Is it important? Click here to find out.

Optimized cellulose media is used for economical filtration, just like the Case R25844 spin-on that you’re replacing. Our cellulose uses the optimal amount of media and pleats in the element to ensure high dirt-holding capacity. The correct number and design of pleats in the element will give you the lowest initial pressure drop, meaning the filter will take longer to reach its change-out pressure drop, usually 25 PSID.

This spin-on filter is compatible with the following fluids, but pressure drop will vary depending on viscosity and temperature:

  • Hydraulic Fluid and Machining Fluids, Water Glycols and Coolants
  • Diesel, Gasoline and other fuels, Lubricating Oils, Synthetic Lubricants, and Process Fluids
  • Turbine and Compressor Lube Oils … And many more fluids

Our Case R25844 is indicated as a replacement and is not manufactured by or affiliated with the OEM or Brand listed. Part numbers and names are used for cross reference only. The spin-on may vary from the image displayed on the left. Please refer to our Terms and Conditions of Sale for answers to any question you may have.